Frequently asked questions about sonoroRADIO (FAQ)

Please check if you have inserted a battery in the battery compartment and if the cover is tight. If this does not solve the problem, check that the subwoofer cover (at the bottom of the unit) has been removed.

Please press the "STOP" button for 3 seconds in "Standby" and then briefly press the "Eject" button to activate or deactivate it.

Press the [DIMMER] button on the top of the unit or on the remote control for about 3 seconds. The display shows [Light HI]. Turn the control knob to adjust the brightness from level 8-15.Press the control knob or the [OK] button on the remote control to confirm the setting.The display shows [Light LO].Turn the control knob to adjust the brightness from level 1-8. Press the control knob or the [OK] button on the remote control to confirm the setting.

We are required by law to design our audio systems so that they can switch off after 20 minutes in an inactive state. You can check and deactivate this function under "System setting" > "Inactive standby".

In stereo, you can connect active speakers via the line-out input. However, these cannot be switched on and off. In addition, you can connect an amplifier via the line-out output and connect passive speakers that can be controlled.

When resetting to factory settings, all stored transmitters are deleted. Even after a firmware update, the transmitters must be stored again.

9 favourites can be saved via the remote control. If more than 9 are desired, this must be done via the unit. The remaining or all 10 favourites can be saved very simply via the "FAV" (Favourites) button.

An automatic change of the time is not preset on our units. To update the time automatically, select the source "Radio" or "Internet". The time is then updated on the basis of RDS data. Of course, you can also change the time manually at any time.